top of page
Here are a few helpful and tested tips to care for your CAP figure
01
There is dust on my Cap figures ?
The manufacturing process on the figure uses Nylon Dust that is laser printed into shape.
To clean this up a simple can of compressed air and a soft clean brush will do the trick.
Always wear a dust mask when doing this to avoid any chance of irritation.
02
The joints feel a little loose, how can I stiffen them?
If the joints on your figure seem a bit 'wobbly' then there are two things to try.
A thin layer of model paint, PVA, Epoxy resin glue or super glue on the sockets will help strengthen and improve the hold.
Take care to allow the glue to fully dry for at least 24 hours to prevent it from completely sticking the joints together.
03
What kind of paints do I use?
Acrylic paints have been tested on these figures and has proven to work very well.
A white layer of Acrylic paint used as a base will enhance any black lines painted on top.
Enamel paints are not recommended for this plastic.
04
What age group are they for
The figures are intended to be used for hobbyists and customiser enthusiasts, and are NOT recommended for young children or infants as there may be a choking risk.
bottom of page